Age | Commit message (Expand) | Author |
2009-04-04 | first cut at a wishbone interface and wrapping the core | matt |
2009-04-04 | copied over from other eth core | matt |
2009-04-04 | reset synchronizer | matt |
2009-04-03 | made pause enabling a pin so we can set it | matt |
2009-04-02 | Properly signals an error and drops the remainder of the packet if there is a... | matt |
2009-04-02 | more thorough tests, including overrun, underrun, crc err, etc. | matt |
2009-04-02 | simulate a hiccup in the filling of the fifo. If long enough, will cause a t... | matt |
2009-04-02 | debug ports for fifo level testing. Normally I wouldn't check this in, but a... | matt |
2009-04-02 | Fix for fifo overruns on eth rx in full duplex. Now send re-pause long befor... | matt |
2009-04-02 | test multiple error types | matt |
2009-04-02 | added a state to ensure the error signal propagates, and now we assert src_rd... | matt |
2009-04-02 | only write one error into fifo | matt |
2009-04-02 | generate error signal | matt |
2009-04-02 | added error output line, alternative to simultaneous sof/eof | matt |
2009-04-02 | logic to interface locallink fifos to our mac | matt |
2009-04-01 | add fifos to interface to the macs | matt |
2009-04-01 | rx seems to work. haven't test error frames | matt |
2009-04-01 | address filtering | matt |
2009-04-01 | only report result for 1 cycle | matt |
2009-04-01 | variable length delay line, based on srl16 | matt |
2009-04-01 | now checks the crc as well for the received side | matt |
2009-04-01 | checkpoint | matt |
2009-03-31 | we now inhibit our own sending when a received pause frame comes. _rx.v is c... | matt |
2009-03-31 | sample packet | matt |
2009-03-31 | cleaned up a little | matt |
2009-03-31 | tx should be fully working now | matt |
2009-03-31 | everything but CRC | matt |
2009-03-31 | nearly there | matt |
2009-03-30 | work in progress on a simpler gigabit-only mac | matt |
2009-03-30 | copied over from other project | matt |
2009-03-30 | new fifos copied over from other project | matt |
2009-03-30 | optional (but not used) additional buffering in eth rx path. | matt |
2009-03-30 | comment out the RMON, which we don't use | matt |
2009-03-09 | copied over old one which works with icarus | matt |
2009-02-26 | timing fix. The line address in the buffers still updates now even if there ... | matt |
2009-02-26 | timing fix, delays the ethernet flow control by a cycle to get it across the ... | matt |
2009-02-26 | remove support for unmodified dbsrx because there is way too much phase noise... | matt |
2009-02-24 | set all debug stuff to zero | matt |
2009-02-23 | support for unmodified dbsrx boards | matt |
2009-02-10 | Merged r10418:10423 from jcorgan/pps into trunk. Adds usrp2::sync_every_pps | jcorgan |
2009-01-31 | work in progress | matt |
2009-01-31 | work in progress | matt |
2009-01-31 | work in progress | matt |
2009-01-31 | first cut at 64 bit time | matt |
2009-01-22 | trial fix for problem when 3 loads with 1 wait state are followed by a barrel... | matt |
2009-01-22 | catching up with shawn. these aren't used here anyway. | matt |
2009-01-22 | detect loss of signal | matt |
2009-01-19 | corrected link up detector | matt |
2009-01-19 | new cordic | matt |
2009-01-19 | widen cordic on tx side | matt |