| Age | Commit message (Expand) | Author |
|---|
| 2009-03-30 | copied over from other project | matt |
| 2009-03-30 | new fifos copied over from other project | matt |
| 2009-03-30 | optional (but not used) additional buffering in eth rx path. | matt |
| 2009-03-30 | comment out the RMON, which we don't use | matt |
| 2009-03-09 | copied over old one which works with icarus | matt |
| 2009-02-26 | timing fix. The line address in the buffers still updates now even if there ... | matt |
| 2009-02-26 | timing fix, delays the ethernet flow control by a cycle to get it across the ... | matt |
| 2009-02-26 | remove support for unmodified dbsrx because there is way too much phase noise... | matt |
| 2009-02-24 | set all debug stuff to zero | matt |
| 2009-02-23 | support for unmodified dbsrx boards | matt |
| 2009-02-10 | Merged r10418:10423 from jcorgan/pps into trunk. Adds usrp2::sync_every_pps | jcorgan |
| 2009-01-31 | work in progress | matt |
| 2009-01-31 | work in progress | matt |
| 2009-01-31 | work in progress | matt |
| 2009-01-31 | first cut at 64 bit time | matt |
| 2009-01-22 | trial fix for problem when 3 loads with 1 wait state are followed by a barrel... | matt |
| 2009-01-22 | catching up with shawn. these aren't used here anyway. | matt |
| 2009-01-22 | detect loss of signal | matt |
| 2009-01-19 | corrected link up detector | matt |
| 2009-01-19 | new cordic | matt |
| 2009-01-19 | widen cordic on tx side | matt |
| 2009-01-19 | clarify comment | matt |
| 2009-01-19 | 24 bit wide z. Can't do this parameterized, unfortunately. | matt |
| 2008-12-15 | pps sync works, meets timing | matt |
| 2008-12-14 | synchronized pps, lots of debug pins changed, works, meets timing | matt |
| 2008-12-13 | reset the phase when we shut down. Aids in sync | matt |
| 2008-12-05 | implemented "reset master clock on next PPS" so we can easily sync multiple u... | matt |
| 2008-12-04 | speed up the diagnostic signals, they were causing timing problems | matt |
| 2008-11-09 | hardware control of leds | matt |
| 2008-10-23 | u2_rev2 now works again | matt |
| 2008-10-22 | make rev2 compile again | matt |
| 2008-10-18 | added in mux for DACs | matt |
| 2008-10-15 | Added firmware support for adc_mux to handle swapping I/Q, etc. | eb |
| 2008-10-11 | New serdes status interrupt, clk_status interrupt. New capability to flush t... | matt |
| 2008-10-08 | moved to appropriate places | matt |
| 2008-10-08 | added the basic wb<-->extram interface and a serdes interrupt to tell link st... | matt |
| 2008-09-21 | catch up with latest pin defs of u2_core | matt |
| 2008-09-21 | attach a 16 bit device to the bus and make it look like a 32 bit device | matt |
| 2008-09-21 | wb_zbt16_b is a quick hack just to be able to safely check the sram. it is n... | matt |
| 2008-09-21 | new directory for files | matt |
| 2008-09-21 | zbt ram controller | matt |
| 2008-09-19 | first cut | matt |
| 2008-09-17 | better debug pins | matt |
| 2008-09-17 | allow fpga to take over sd card interface from cpld | matt |
| 2008-09-17 | allow fpga to take over SD card interface | matt |
| 2008-09-17 | control CS line on SD card | matt |
| 2008-09-11 | Merged r9505:9553 from old usrp2/trunk into trunk/usrp2 | jcorgan |
| 2008-09-08 | Merged r9433:9527 from features/gr-usrp2 into trunk. Adds usrp2 and gr-usrp2... | jcorgan |
