1 files changed, 0 insertions, 60 deletions
diff --git a/Resources/OpenPLCv2/firmware/ADC.test.arduino/trial2.c b/Resources/OpenPLCv2/firmware/ADC.test.arduino/trial2.c
deleted file mode 100644
index e8cdfcf..0000000
--- a/Resources/OpenPLCv2/firmware/ADC.test.arduino/trial2.c
+++ /dev/null
@@ -1,60 +0,0 @@
-/*
-
-SSTRB goes low when the ADC begins a conversion and goes
-high when the conversion is finished
-
-SSTRB goes low at the beginning of calibration and goes
-high to signal the end of calibration
-
-Control byte format
-7 - (MSB) START The first logic "1" bit, after CS goes low, defines the beginning of the Control Byte
-6 - UNI/BIP 1 = unipolar, 0 = bipolar
-5 - INT/EXT Selects the internal or external conversion clock. 1 = Internal, 0 = External.
-4 - M1    M1   M0   MODE
-3 - M0    0    0     24 External clocks per conversion (short acquisition mode)
-          0    1     Start Calibration. Starts internal calibration.
-          1    0     Software power-down mode
-          1    1     32 External clocks per conversion (long acquisition mode)
-2 - programmable bit P2
-1 - programmable bit P1
-0 - programmable bit P0
-
-*/
-
-#define CALIBRATION   0b11101000
-#define START         0b11100000   
-
-#include <SPI.h>
-int  sstrb    =  8;
-int  adcPin   =  9;
-int  sdPin    = 10;
-unsigned int  adcValue =  0;
-byte  LowByte,HighByte;
-
-void setup() {
-  pinMode(sstrb,INPUT);
-  pinMode(adcPin, OUTPUT);
-  pinMode(sdPin, OUTPUT);
-  digitalWrite(adcPin,HIGH);
-  digitalWrite(sdPin,HIGH);
-  Serial.begin(115200);
-  SPI.begin();
-  SPI.setBitOrder(MSBFIRST);
-  SPI.setClockDivider(SPI_CLOCK_DIV4);
-  SPI.setDataMode(SPI_MODE0);
-  delay(100);
-  digitalWrite(adcPin,LOW);
-  SPI.transfer(CALIBRATION);        //kalibrálás
-  while(!digitalRead(sstrb)){}
-  SPI.transfer(START);        //mérés indítás
-}
-
-
-void loop(){
-  while(!digitalRead(sstrb)){}
-  adcValue=SPI.transfer(START);
-  Serial.print("ADC: ");
-  Serial.println(adcValue);
-
- 
-}
-\ No newline at end of file