1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
|
/*
* MMC definitions for OMAP2
*
* Copyright (C) 2006 Nokia Corporation
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#ifndef __OMAP2_MMC_H
#define __OMAP2_MMC_H
#include <linux/types.h>
#include <linux/device.h>
#include <linux/mmc/host.h>
#include <plat/board.h>
#define OMAP15XX_NR_MMC 1
#define OMAP16XX_NR_MMC 2
#define OMAP1_MMC_SIZE 0x080
#define OMAP1_MMC1_BASE 0xfffb7800
#define OMAP1_MMC2_BASE 0xfffb7c00 /* omap16xx only */
#define OMAP24XX_NR_MMC 2
#define OMAP2420_MMC_SIZE OMAP1_MMC_SIZE
#define OMAP2_MMC1_BASE 0x4809c000
#define OMAP4_MMC_REG_OFFSET 0x100
#define OMAP_MMC_MAX_SLOTS 2
/*
* struct omap_mmc_dev_attr.flags possibilities
*
* OMAP_HSMMC_SUPPORTS_DUAL_VOLT: Some HSMMC controller instances can
* operate with either 1.8Vdc or 3.0Vdc card voltages; this flag
* should be set if this is the case. See for example Section 22.5.3
* "MMC/SD/SDIO1 Bus Voltage Selection" of the OMAP34xx Multimedia
* Device Silicon Revision 3.1.x Revision ZR (July 2011) (SWPU223R).
*
* OMAP_HSMMC_BROKEN_MULTIBLOCK_READ: Multiple-block read transfers
* don't work correctly on some MMC controller instances on some
* OMAP3 SoCs; this flag should be set if this is the case. See
* for example Advisory 2.1.1.128 "MMC: Multiple Block Read
* Operation Issue" in _OMAP3530/3525/3515/3503 Silicon Errata_
* Revision F (October 2010) (SPRZ278F).
*/
#define OMAP_HSMMC_SUPPORTS_DUAL_VOLT BIT(0)
#define OMAP_HSMMC_BROKEN_MULTIBLOCK_READ BIT(1)
struct omap_mmc_dev_attr {
u8 flags;
};
struct omap_mmc_platform_data {
/* back-link to device */
struct device *dev;
/* number of slots per controller */
unsigned nr_slots:2;
/* set if your board has components or wiring that limits the
* maximum frequency on the MMC bus */
unsigned int max_freq;
/* switch the bus to a new slot */
int (*switch_slot)(struct device *dev, int slot);
/* initialize board-specific MMC functionality, can be NULL if
* not supported */
int (*init)(struct device *dev);
void (*cleanup)(struct device *dev);
void (*shutdown)(struct device *dev);
/* To handle board related suspend/resume functionality for MMC */
int (*suspend)(struct device *dev, int slot);
int (*resume)(struct device *dev, int slot);
/* Return context loss count due to PM states changing */
int (*get_context_loss_count)(struct device *dev);
u64 dma_mask;
/* Integrating attributes from the omap_hwmod layer */
u8 controller_flags;
/* Register offset deviation */
u16 reg_offset;
struct omap_mmc_slot_data {
/*
* 4/8 wires and any additional host capabilities
* need to OR'd all capabilities (ref. linux/mmc/host.h)
*/
u8 wires; /* Used for the MMC driver on omap1 and 2420 */
u32 caps; /* Used for the MMC driver on 2430 and later */
u32 pm_caps; /* PM capabilities of the mmc */
/*
* nomux means "standard" muxing is wrong on this board, and
* that board-specific code handled it before common init logic.
*/
unsigned nomux:1;
/* switch pin can be for card detect (default) or card cover */
unsigned cover:1;
/* use the internal clock */
unsigned internal_clock:1;
/* nonremovable e.g. eMMC */
unsigned nonremovable:1;
/* Try to sleep or power off when possible */
unsigned power_saving:1;
/* If using power_saving and the MMC power is not to go off */
unsigned no_off:1;
/* eMMC does not handle power off when not in sleep state */
unsigned no_regulator_off_init:1;
/* Regulator off remapped to sleep */
unsigned vcc_aux_disable_is_sleep:1;
/* we can put the features above into this variable */
#define HSMMC_HAS_PBIAS (1 << 0)
#define HSMMC_HAS_UPDATED_RESET (1 << 1)
unsigned features;
int switch_pin; /* gpio (card detect) */
int gpio_wp; /* gpio (write protect) */
int (*set_bus_mode)(struct device *dev, int slot, int bus_mode);
int (*set_power)(struct device *dev, int slot,
int power_on, int vdd);
int (*get_ro)(struct device *dev, int slot);
void (*remux)(struct device *dev, int slot, int power_on);
/* Call back before enabling / disabling regulators */
void (*before_set_reg)(struct device *dev, int slot,
int power_on, int vdd);
/* Call back after enabling / disabling regulators */
void (*after_set_reg)(struct device *dev, int slot,
int power_on, int vdd);
/* if we have special card, init it using this callback */
void (*init_card)(struct mmc_card *card);
/* return MMC cover switch state, can be NULL if not supported.
*
* possible return values:
* 0 - closed
* 1 - open
*/
int (*get_cover_state)(struct device *dev, int slot);
const char *name;
u32 ocr_mask;
/* Card detection IRQs */
int card_detect_irq;
int (*card_detect)(struct device *dev, int slot);
unsigned int ban_openended:1;
} slots[OMAP_MMC_MAX_SLOTS];
};
/* called from board-specific card detection service routine */
extern void omap_mmc_notify_cover_event(struct device *dev, int slot,
int is_closed);
#if defined(CONFIG_MMC_OMAP) || defined(CONFIG_MMC_OMAP_MODULE) || \
defined(CONFIG_MMC_OMAP_HS) || defined(CONFIG_MMC_OMAP_HS_MODULE)
void omap1_init_mmc(struct omap_mmc_platform_data **mmc_data,
int nr_controllers);
void omap242x_init_mmc(struct omap_mmc_platform_data **mmc_data);
int omap_mmc_add(const char *name, int id, unsigned long base,
unsigned long size, unsigned int irq,
struct omap_mmc_platform_data *data);
#else
static inline void omap1_init_mmc(struct omap_mmc_platform_data **mmc_data,
int nr_controllers)
{
}
static inline void omap242x_init_mmc(struct omap_mmc_platform_data **mmc_data)
{
}
static inline int omap_mmc_add(const char *name, int id, unsigned long base,
unsigned long size, unsigned int irq,
struct omap_mmc_platform_data *data)
{
return 0;
}
#endif
#endif
|
