diff options
Diffstat (limited to 'ANDROID_3.4.5/drivers/net/ethernet/stmicro/stmmac/Kconfig')
-rw-r--r-- | ANDROID_3.4.5/drivers/net/ethernet/stmicro/stmmac/Kconfig | 100 |
1 files changed, 0 insertions, 100 deletions
diff --git a/ANDROID_3.4.5/drivers/net/ethernet/stmicro/stmmac/Kconfig b/ANDROID_3.4.5/drivers/net/ethernet/stmicro/stmmac/Kconfig deleted file mode 100644 index 03642834..00000000 --- a/ANDROID_3.4.5/drivers/net/ethernet/stmicro/stmmac/Kconfig +++ /dev/null @@ -1,100 +0,0 @@ -config STMMAC_ETH - tristate "STMicroelectronics 10/100/1000 Ethernet driver" - depends on HAS_IOMEM - select NET_CORE - select MII - select PHYLIB - select CRC32 - ---help--- - This is the driver for the Ethernet IPs are built around a - Synopsys IP Core and only tested on the STMicroelectronics - platforms. - -if STMMAC_ETH - -config STMMAC_PLATFORM - tristate "STMMAC platform bus support" - depends on STMMAC_ETH - default y - ---help--- - This selects the platform specific bus support for - the stmmac device driver. This is the driver used - on many embedded STM platforms based on ARM and SuperH - processors. - If you have a controller with this interface, say Y or M here. - - If unsure, say N. - -config STMMAC_PCI - tristate "STMMAC support on PCI bus (EXPERIMENTAL)" - depends on STMMAC_ETH && PCI && EXPERIMENTAL - ---help--- - This is to select the Synopsys DWMAC available on PCI devices, - if you have a controller with this interface, say Y or M here. - - This PCI support is tested on XLINX XC2V3000 FF1152AMT0221 - D1215994A VIRTEX FPGA board. - - If unsure, say N. - -config STMMAC_DEBUG_FS - bool "Enable monitoring via sysFS " - default n - depends on STMMAC_ETH && DEBUG_FS - ---help--- - The stmmac entry in /sys reports DMA TX/RX rings - or (if supported) the HW cap register. - -config STMMAC_DA - bool "STMMAC DMA arbitration scheme" - default n - ---help--- - Selecting this option, rx has priority over Tx (only for Giga - Ethernet device). - By default, the DMA arbitration scheme is based on Round-robin - (rx:tx priority is 1:1). - -config STMMAC_TIMER - bool "STMMAC Timer optimisation" - default n - depends on RTC_HCTOSYS_DEVICE - ---help--- - Use an external timer for mitigating the number of network - interrupts. Currently, for SH architectures, it is possible - to use the TMU channel 2 and the SH-RTC device. - -choice - prompt "Select Timer device" - depends on STMMAC_TIMER - -config STMMAC_TMU_TIMER - bool "TMU channel 2" - depends on CPU_SH4 - ---help--- - -config STMMAC_RTC_TIMER - bool "Real time clock" - depends on RTC_CLASS - ---help--- - -endchoice - -choice - prompt "Select the DMA TX/RX descriptor operating modes" - depends on STMMAC_ETH - ---help--- - This driver supports DMA descriptor to operate both in dual buffer - (RING) and linked-list(CHAINED) mode. In RING mode each descriptor - points to two data buffer pointers whereas in CHAINED mode they - points to only one data buffer pointer. - -config STMMAC_RING - bool "Enable Descriptor Ring Mode" - -config STMMAC_CHAINED - bool "Enable Descriptor Chained Mode" - -endchoice - - -endif |