diff options
Diffstat (limited to 'include/linux/usb/otg.h')
-rw-r--r-- | include/linux/usb/otg.h | 279 |
1 files changed, 279 insertions, 0 deletions
diff --git a/include/linux/usb/otg.h b/include/linux/usb/otg.h new file mode 100644 index 00000000..38ab3f46 --- /dev/null +++ b/include/linux/usb/otg.h @@ -0,0 +1,279 @@ +/* USB OTG (On The Go) defines */ +/* + * + * These APIs may be used between USB controllers. USB device drivers + * (for either host or peripheral roles) don't use these calls; they + * continue to use just usb_device and usb_gadget. + */ + +#ifndef __LINUX_USB_OTG_H +#define __LINUX_USB_OTG_H + +#include <linux/notifier.h> + +/* OTG defines lots of enumeration states before device reset */ +enum usb_otg_state { + OTG_STATE_UNDEFINED = 0, + + /* single-role peripheral, and dual-role default-b */ + OTG_STATE_B_IDLE, + OTG_STATE_B_SRP_INIT, + OTG_STATE_B_PERIPHERAL, + + /* extra dual-role default-b states */ + OTG_STATE_B_WAIT_ACON, + OTG_STATE_B_HOST, + + /* dual-role default-a */ + OTG_STATE_A_IDLE, + OTG_STATE_A_WAIT_VRISE, + OTG_STATE_A_WAIT_BCON, + OTG_STATE_A_HOST, + OTG_STATE_A_SUSPEND, + OTG_STATE_A_PERIPHERAL, + OTG_STATE_A_WAIT_VFALL, + OTG_STATE_A_VBUS_ERR, +}; + +enum usb_phy_events { + USB_EVENT_NONE, /* no events or cable disconnected */ + USB_EVENT_VBUS, /* vbus valid event */ + USB_EVENT_ID, /* id was grounded */ + USB_EVENT_CHARGER, /* usb dedicated charger */ + USB_EVENT_ENUMERATED, /* gadget driver enumerated */ +}; + +struct usb_phy; + +/* for transceivers connected thru an ULPI interface, the user must + * provide access ops + */ +struct usb_phy_io_ops { + int (*read)(struct usb_phy *x, u32 reg); + int (*write)(struct usb_phy *x, u32 val, u32 reg); +}; + +struct usb_otg { + u8 default_a; + + struct usb_phy *phy; + struct usb_bus *host; + struct usb_gadget *gadget; + + /* bind/unbind the host controller */ + int (*set_host)(struct usb_otg *otg, struct usb_bus *host); + + /* bind/unbind the peripheral controller */ + int (*set_peripheral)(struct usb_otg *otg, + struct usb_gadget *gadget); + + /* effective for A-peripheral, ignored for B devices */ + int (*set_vbus)(struct usb_otg *otg, bool enabled); + + /* for B devices only: start session with A-Host */ + int (*start_srp)(struct usb_otg *otg); + + /* start or continue HNP role switch */ + int (*start_hnp)(struct usb_otg *otg); + +}; + +/* + * the otg driver needs to interact with both device side and host side + * usb controllers. it decides which controller is active at a given + * moment, using the transceiver, ID signal, HNP and sometimes static + * configuration information (including "board isn't wired for otg"). + */ +struct usb_phy { + struct device *dev; + const char *label; + unsigned int flags; + + enum usb_otg_state state; + enum usb_phy_events last_event; + + struct usb_otg *otg; + + struct device *io_dev; + struct usb_phy_io_ops *io_ops; + void __iomem *io_priv; + + /* for notification of usb_phy_events */ + struct atomic_notifier_head notifier; + + /* to pass extra port status to the root hub */ + u16 port_status; + u16 port_change; + + /* initialize/shutdown the OTG controller */ + int (*init)(struct usb_phy *x); + void (*shutdown)(struct usb_phy *x); + + /* effective for B devices, ignored for A-peripheral */ + int (*set_power)(struct usb_phy *x, + unsigned mA); + + /* for non-OTG B devices: set transceiver into suspend mode */ + int (*set_suspend)(struct usb_phy *x, + int suspend); + +}; + + +/* for board-specific init logic */ +extern int usb_set_transceiver(struct usb_phy *); + +#if defined(CONFIG_NOP_USB_XCEIV) || (defined(CONFIG_NOP_USB_XCEIV_MODULE) && defined(MODULE)) +/* sometimes transceivers are accessed only through e.g. ULPI */ +extern void usb_nop_xceiv_register(void); +extern void usb_nop_xceiv_unregister(void); +#else +static inline void usb_nop_xceiv_register(void) +{ +} + +static inline void usb_nop_xceiv_unregister(void) +{ +} +#endif + +/* helpers for direct access thru low-level io interface */ +static inline int usb_phy_io_read(struct usb_phy *x, u32 reg) +{ + if (x->io_ops && x->io_ops->read) + return x->io_ops->read(x, reg); + + return -EINVAL; +} + +static inline int usb_phy_io_write(struct usb_phy *x, u32 val, u32 reg) +{ + if (x->io_ops && x->io_ops->write) + return x->io_ops->write(x, val, reg); + + return -EINVAL; +} + +static inline int +usb_phy_init(struct usb_phy *x) +{ + if (x->init) + return x->init(x); + + return 0; +} + +static inline void +usb_phy_shutdown(struct usb_phy *x) +{ + if (x->shutdown) + x->shutdown(x); +} + +/* for usb host and peripheral controller drivers */ +#ifdef CONFIG_USB_OTG_UTILS +extern struct usb_phy *usb_get_transceiver(void); +extern void usb_put_transceiver(struct usb_phy *); +extern const char *otg_state_string(enum usb_otg_state state); +#else +static inline struct usb_phy *usb_get_transceiver(void) +{ + return NULL; +} + +static inline void usb_put_transceiver(struct usb_phy *x) +{ +} + +static inline const char *otg_state_string(enum usb_otg_state state) +{ + return NULL; +} +#endif + +/* Context: can sleep */ +static inline int +otg_start_hnp(struct usb_otg *otg) +{ + if (otg && otg->start_hnp) + return otg->start_hnp(otg); + + return -ENOTSUPP; +} + +/* Context: can sleep */ +static inline int +otg_set_vbus(struct usb_otg *otg, bool enabled) +{ + if (otg && otg->set_vbus) + return otg->set_vbus(otg, enabled); + + return -ENOTSUPP; +} + +/* for HCDs */ +static inline int +otg_set_host(struct usb_otg *otg, struct usb_bus *host) +{ + if (otg && otg->set_host) + return otg->set_host(otg, host); + + return -ENOTSUPP; +} + +/* for usb peripheral controller drivers */ + +/* Context: can sleep */ +static inline int +otg_set_peripheral(struct usb_otg *otg, struct usb_gadget *periph) +{ + if (otg && otg->set_peripheral) + return otg->set_peripheral(otg, periph); + + return -ENOTSUPP; +} + +static inline int +usb_phy_set_power(struct usb_phy *x, unsigned mA) +{ + if (x && x->set_power) + return x->set_power(x, mA); + return 0; +} + +/* Context: can sleep */ +static inline int +usb_phy_set_suspend(struct usb_phy *x, int suspend) +{ + if (x->set_suspend != NULL) + return x->set_suspend(x, suspend); + else + return 0; +} + +static inline int +otg_start_srp(struct usb_otg *otg) +{ + if (otg && otg->start_srp) + return otg->start_srp(otg); + + return -ENOTSUPP; +} + +/* notifiers */ +static inline int +usb_register_notifier(struct usb_phy *x, struct notifier_block *nb) +{ + return atomic_notifier_chain_register(&x->notifier, nb); +} + +static inline void +usb_unregister_notifier(struct usb_phy *x, struct notifier_block *nb) +{ + atomic_notifier_chain_unregister(&x->notifier, nb); +} + +/* for OTG controller drivers (and maybe other stuff) */ +extern int usb_bus_start_enum(struct usb_bus *bus, unsigned port_num); + +#endif /* __LINUX_USB_OTG_H */ |